Demo Preview

300-710 SNCF Safe Question Preview

This public preview shows limited demo-safe questions only. Correct answers, full explanations, paid-only media, private IDs, and attempt data are not included.

IntegrationConfigurationMultiple ChoiceMulti Select
Start Interactive DemoExam Landing Page

Preview Questions

Multiple ChoiceIntegration
Question 1. What is the advantage of having Cisco Firepower devices send events to Cisco Threat Response via the security services exchange portal directly as opposed to using syslog?
A. All types of Cisco Firepower devices are supported.
B. An on-premises proxy server does not need to be set up and maintained.
C. Cisco Firepower devices do not need to be connected to the Internet.
D. Supports all devices that are running supported versions of Cisco Firepower.
Open safe question previewReport Question
Multiple ChoiceConfiguration
Question 2. An engineer wants to change an existing transparent Cisco FTD to routed mode. The device controls traffic between two network segments. Which action is mandatory to allow hosts to reestablish communication between these two segments after the change?
A. remove the existing dynamic routing protocol settings.
B. configure multiple BVIs to route between segments.
C. assign unique VLAN IDs to each firewall interface.
D. implement non-overlapping IP subnets on each segment.
Open safe question previewReport Question
Multi SelectConfiguration
Question 3. Which two features of Cisco AMP for Endpoints allow for an uploaded file to be blocked? (Choose two.)
A. application blocking
B. simple custom detection
C. file repository
D. exclusions
E. application whitelisting
Open safe question previewReport Question
Multiple ChoiceConfiguration
Question 4. Refer to the exhibit. An engineer is configuring an instance of Cisco Secure Firewall Threat Defense with interfaces in IPS Inline Pair mode. What must be configured on interface e1/6 to accomplish the requirement?
A. propagate link state disabled
B. inline set MTU set to 1500
C. FailSafe disabled
D. security zone set to OUTSIDE_ZONE
Open safe question previewReport Question
Multiple ChoiceConfiguration
Question 5. Which action must be taken on the Cisco FMC when a packet bypass is configured in case the Snort engine is down or a packet takes too long to process?
A. Enable Inspect Local Router Traffic
B. Enable Automatic Application Bypass
C. Configure Fastpath rules to bypass inspection
D. Add a Bypass Threshold policy for failures
Open safe question previewReport Question