Demo Preview

300-615 DCIT Safe Question Preview

This public preview shows limited demo-safe questions only. Correct answers, full explanations, paid-only media, private IDs, and attempt data are not included.

NetworkManagement and OperationsStorage NetworkMultiple Choice
Start Interactive DemoExam Landing Page

Preview Questions

Multiple ChoiceNetwork
Question 1. Refer to the exhibit. Refer to the exhibit. An engineer troubleshoots an OSPF neighborship problem between Router R2 and Router R10. Which action resolves the problem?
A. Change area ID on Router R10
B. Resolve unicast reply from Router R2
C. Resolve authentication type on Router R10
D. Change router ID on Router R10
Open safe question previewReport Question
Multiple ChoiceNetwork
Question 2. A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue?
A. 1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels
B. 2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
B. 1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
C. 3) Check for runtime link down status
C. 1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
D. 4) Reseat the affected IOM.
D. 1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
F. 2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
G. 3) Check for runtime link down status
H. 4) Reseat the affected IOM.
J. 2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
K. 3) Check for runtime link down status.
L. 4) Reseat the affected IOM.
N. 2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
O. 3) Check for runtime link down status.
P. 4) Reseat the affected IOM.
Open safe question previewReport Question
Multiple ChoiceManagement and Operations
Question 3. Refer to the exhibit. The EEM script fails to send an SNMP trap when a user attempts to enter configuration mode. Which configuration is missing from the script?
A. event statement
B. event-default action statement
C. policy-default action statement
D. IP address of the SNMP server
Open safe question previewReport Question
Multiple ChoiceNetwork
Question 4. Refer to the exhibit. A new Cisco Nexus 5548 Switch connects to a network. SAN switching is configured on the switch. The switch fc2/10 NP uplink is shown in the exhibit. Which action ensures that fc2/10 is in an up state?
A. Replace the SFP port module in fc2/10.
B. Configure the admin port type E on the upstream switch that connects the port.
C. Enable NPIV on the upstream switch that connects the port.
D. Configure the BB_credit buffers on the upstream switch that connects the port.
Open safe question previewReport Question
Multiple ChoiceStorage Network
Question 5. An engineer must configure Linux hosts that are deployed on Cisco UCS B-Series Servers to boot from SAN. The SAN boot policy is configured in Cisco UCS Manager, and the boot order is verified to be set as expected However, the Linux hosts fail to boot. Which action resolves the issue?
A. Remove all of the local storage that is installed
B. Delete and reconfigure the pWWN of the SAN boot target
C. Remove all of the ISO images that are mounted as a virtual CD-ROM
D. Delete and reconfigure the boot LUN
Open safe question previewReport Question