Demo Preview

220-1201 Safe Question Preview

This public preview shows limited demo-safe questions only. Correct answers, full explanations, paid-only media, private IDs, and attempt data are not included.

Hardware and network troubleshootingNetworkingVirtualization and cloud computingHardwareMulti SelectMultiple Choice
Start Interactive DemoExam Landing Page

Preview Questions

Multi SelectHardware and network troubleshooting
Question 1. SIMULATION A third-party contractor recently installed a new switch, router, and cabling for a small corporate office. After the installation, users started experiencing issues connecting to resources over the network. INSTRUCTIONS Click on each PC and server to review outputs. From the remediation section on the right, select an issue and solution for each device.
A. PC 1: Correct the duplicate IPv4 address by assigning a unique address in the 192.168.1.0/24 network.
B. PC 2: Use the valid DHCP configuration, which assigns 192.168.1.12/24 with gateway 192.168.1.50.
C. Server 1: Change the subnet mask from 255.255.255.255 to 255.255.255.0 and assign a unique IPv4 address instead of 192.168.1.1.
D. Server 2: Change the default gateway from 192.168.1.5 to 192.168.1.50.
Open safe question previewReport Question
Multiple ChoiceNetworking
Question 2. SIMULATION A technician is installing a wireless access point and is required to run all cabling and make patch cords if necessary. INSTRUCTIONS Part 1 For each cable type, click the (+) to select the appropriate connector and tool. part 2 An access point was moved and no longer has connectivity. Connect the access point, patch panel, and switch by clicking the (+) to select the appropriate cable end for each corresponding location to create a link. The link will be visible after making the second selection of each pair. Cable ends may be used multiple times, and all placeholders will be filled.
A. A. Top cable: RJ11 + Crimper Middle cable: LC + Optical Crimper Bottom cable: RJ45 + Crimper
B. B. Top cable: RJ45 + Punchdown Middle cable: LC + Crimper Bottom cable: RJ11 + Optical Crimper
C. C. Top cable: RJ11 + Punchdown Middle cable: RJ45 + Optical Crimper Bottom cable: LC + Crimper
Open safe question previewReport Question
Multiple ChoiceVirtualization and cloud computing
Question 3. Which of the following is a characteristic of a Type 1 hypervisor?
A. Host OS required
B. Bare-metal server installation
C. Lightweight OS
D. Local configuration options
Open safe question previewReport Question
Multiple ChoiceHardware
Question 4. A company requires a storage solution that combines performance and redundancy for a main database server with high levels of read/write operations. Which of the following storage configurations best meets these requirements?
A. RAID 0
B. RAID 5
C. RAID 6
D. RAID 10
Open safe question previewReport Question
Multi SelectHardware and network troubleshooting
Question 5. A technician is diagnosing several device issues reported by employees. INSTRUCTIONS Click on each device to review the issue. Then select the appropriate issue and solution from the drop-down menu. Each option may be used more than once. Answer:
A. Mobile device battery drains quickly — replace the battery
B. Laptop has poor performance — upgrade the hard drive
C. Laptop cannot boot from the selected image or partition — correct the boot partition or boot configuration
D. Laptop is overheating — clean the vents and cooling assembly
E. Mobile device has incorrect network settings — reset or reconfigure the network settings
F. Monitor displays no signal — select the correct monitor input and verify the video connection
G. Projector or display has an incorrect image configuration — adjust the display resolution and refresh rate
H. System is unstable because of overclocking — disable overclocking in the BIOS and restore supported settings
I. Display panel is physically damaged — replace the display
Open safe question previewReport Question